Cisco 7925G Administration Guide

Enabled
Indicates whether or not the profile is enabled.
Name
Lists the name for the profile.
SSID
Lists the SSID used by the profile.
Status
Indicates which profiles are active or inactive.
To display the Network Profiles list, access the web page for the phone as described Access Phone Web Page,
on page 69, and then click the Network Profiles hyperlink.
For more information about configuring network profiles, see the following sections.
Network Profile Settings
You can configure the profile settings using this web page area. You can also modify or view configured
profiles from this web page area. The following table describes the basic and advanced profile settings and
provides references for more information.
To display Network Profile (1-4) Settings, access the web page for the phone as described in Access Phone
Web Page, on page 69, and then click the Profile (1-4) hyperlink.
Table 19: Basic Network Profile Settings
For more information, see …
DescriptionItem
Wireless
Descriptive name for the profile.Profile Name
AP Association, on page 34Assigns the Service Set Identifier
(SSID) to this profile. You must
assign the same SSID to the phone
that is also assigned to access points
in the wireless network.
SSID
Enables editing of the profile.Edit Profile
802.11 Standards for WLAN
Communications, on page 24
Set for the type of power saving
mode used in the WLAN. Options
are:
•
U-APSD/PS-Poll
•
None
Call Power Save Mode
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
75
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Network Profile Settings

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g