Cisco 7925G Administration Guide

Bulk Provisioning
The Cisco Unified Wireless IP Phones support a Bulk Provisioning Utility. For more information, see the
Bulk Deployment Utility Guide at http://www.cisco.com/web/software/282074239/14006/
792xBD.1-0-Readme.pdf.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G
Startup
After charging the battery and configuring the wireless IP phone, you are ready to power on the phone and
connect to the WLAN.
To power on the Cisco Unified Wireless IP Phone, press and hold the Power On button until the phone begins
its startup process by cycling through these steps:
1
The phone displays the Cisco Systems screen.
2
The phone screen displays these messages as the phone starts up:
•
Locating Network Services
•
Configuring IP
•
Network Up
•
Configuring Unified CMList
•
Registering
3
The following information displays on the main phone screen:
•
Current time and date
•
Primary directory number
•
Main screen icons for four menus and Help
•
Your current options on status line
•
Softkey labels (Messages and Options)
When the phone passes through these stages with no errors, the phone has started up properly. Now the phone
is in standby mode and is ready to place or receive calls.
The signal icon in the upper left corner shows the strength of the signal between the wireless access point and
the phone. The phone must have an adequate signal to successfully place or receive calls. If the signal icon
displays only one bar, the weak signal can cause problems with phone performance.
Related Topics
Phone Startup Process, on page 64
Startup and Connectivity Problems, on page 209
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
63
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup
Bulk Provisioning

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g