EasyManuals Logo

Cisco 7925G Administration Guide

Cisco 7925G
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
ASCII
For ASCII keys, you enter a character string that uses 0-9, A-Z (upper and lower case), including
symbols and is from 8 to 63 characters in length; for example, GREG12356789ZXYW
Set Up PSK
To set up a PSK in the Wireless Credentials area, follow these steps:
Procedure
Step 1
Choose the network profile that uses Auto (AKM) to enable the WPA Pre-shared key or WPA2 Pre-shared
key.
Step 2
In the Key Type area, choose one of these character formats:
Hex
ASCII
Step 3
Enter an ASCII string or hexadecimal digits in the Passphrase/Pre-shared key field.
Step 4
Click Save to make the change.
Wireless Encryption
If your wireless network uses WEP encryption, and you set the Authentication Mode as Open + WEP or
Shared Key + WEP, you must enter an ASCII or hexadecimal WEP Key.
The WEP Keys for the phone must match the WEP Keys assigned to the access point. Cisco Unified Wireless
IP Phone and Cisco Aironet Access Points support both 40-bit and 128-bit encryption keys.
WEP Key Formats
You must use one of these formats when setting up a WEP key:
Hexadecimal
For hexadecimal keys, you use one of the following key sizes:
40-bit
You enter a 10-digit encryption key string that uses the hex digits (0-9 and A-F); for example,
ABCD123456.
128-bit
You enter a 26-digit encryption key string that uses the hex digits (0-9 and A-F); for example,
AB123456789CD01234567890EF.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
84
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Wireless Security Credentials

Table of Contents

Other manuals for Cisco 7925G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7925G and is the answer not in the manual?

Cisco 7925G Specifications

General IconGeneral
Keypad number of keys12
Display diagonal2 \
Display resolution176 x 220 pixels
Call waitingYes
Lines quantity6 lines
Voice codecsG.711a, G.722, G.729a, iLBC
Security algorithms128-bit WEP, SSL/TLS, WPA
Supported network protocolsDHCP, TFTP, DNS, SCCP, SRST
Input voltage100 - 240 V
Dimensions (WxDxH)52 x 20 x 127 mm
Minimum system requirementsCisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency50/60 Hz
Storage temperature (T-T)-30 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 95 %
Product typeIP Phone
Product colorGray
SafetyUL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standardsIEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e
Weight and Dimensions IconWeight and Dimensions
Weight138 g

Related product manuals