Cisco 7925G Administration Guide

Procedure
Step 1
Choose the network profile that you want to configure.
Step 2
Under the IP Network Configuration area, choose Use the following IP addresses and DNS servers.
Step 3
Enter the required IP addresses. See Network Configuration Fields When DHCP Not in Use, on page 93 for
descriptions of these fields.
Step 4
Click Save to make the change.
Network Configuration Fields When DHCP Not in Use
When DHCP is not in use, the fields listed in the following table need to be statically configured.
Table 21: Network Configuration fields
DescriptionStatic setting
IP address of the phoneIP Address
Subnet mask used by the phoneSubnet Mask
Primary gateway used by the phoneDefault Router 1
Primary DNS server used by the phone
Optional backup DNS server used by the phone
DNS Server 1
DNS Server 2
Primary TFTP server used by the phone
Optional backup TFTP server used by the phone
TFTP Server 1
TFTP Server 2
Name of the DNS in which the phone residesDomain Name
Set Up Alternate TFTP Server
If you use DHCP to direct the phones to a TFTP server, you can also assign an alternative TFTP server to
some phones instead of the one assigned by DHCP.
If you disable DHCP, then you must use these steps to set up the TFTP server for the phone.Note
To assign an alternate TFTP server to a phone, follow these steps:
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
93
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Set Up Alternate TFTP Server

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g