Cisco 7925G Administration Guide

◦
Avalanche Manager Agent
◦
Avalanche Management Console
•
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Firmware Release 1.3(1) or later
•
Configuration Utility (CU) for Wavelink Avalanche
•
DHCP server
•
Cisco Unified Communications Manager
Best Practices
This section describes the best practices recommended for setting up and using the CU on the Wavelink
Avalanche server.
•
Ensure that the phone is registered to Cisco Unified Communications Manager.
•
Try out this process with one or two phones before deploying to many phones.
•
Set up a VLAN that has access only to the Wavelink server.
•
Configure DHCP Option 149 with the Wavelink server IP address. If you do not configure this option,
see Set Up Wavelink Server Address from Phone, on page 134.
• Configure a Cisco Access Point to use a default SSID of “cisco” with open authentication and no
encryption.
Wavelink Server IP Address Setup
If you did not configure DHCP Option 149 with the Wavelink server IP address, you must manually assign
it.
Do not perform this task if you previously configured the Wavelink server address using DHCP Option
149.
Note
The following sections describe the methods to assign the Wavelink server on the phone.
Set Up Wavelink Server Address from Phone
To assign the Wavelink server from the phone, follow these steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
134
Wavelink Avalanche Server
Best Practices

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g