Cisco 7925G Administration Guide

Procedure
Step 1
Turn on the phone.
Step 2
Verify that the phone is installed with the required firmware version and is registered to Cisco Unified
Communications Manager.
Step 3
Choose SETTINGS > System Configuration > Wavelink.
Step 4
To unlock the phone, press **#.
Step 5
In the Alternate Wavelink Server option, choose Yes.
Step 6
Enter the IP address of the Wavelink server, and press Save.
Set Up Wavelink Server Address from Phone Web Page
To assign the Wavelink server using the phone web page, follow these steps.
Procedure
Step 1
From the phone web page, choose Wavelink Settings from the left pane.
Under Wavelink Settings, make sure that the server is enabled.
Step 2
Click Use the following Server and enter the IP address of the server.
Step 3
Click Save.
Set Up and Use CU
This section describes the tasks for configuring and using the CU from the Wavelink Management Console.
The CU is labeled as 7921G but the CU works for all 792X phones.Note
To set up and use the CU from the Wavelink Management Console, perform the following tasks.
Procedure
Step 1
Assign attributes for the phone. For more information, see Phone Attributes Setup, on page 136.
Step 2
Install the CU on Wavelink. For more information, see Install CU File, on page 137.
Step 3
Update the configuration files. For more information, see Update Configuration Files, on page 137.
Step 4
Update the phones. For more information, see Phone Attributes Setup, on page 136.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
135
Wavelink Avalanche Server
Set Up Wavelink Server Address from Phone Web Page

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g