Section 1 — Introduction
Part No. 750-363 1-7
1.3 OPTIONAL EQUIPMENT
Certain project-specific options may have been supplied with the boiler if these options were specified at
the time of order entry. In addition, some options may have been provided (by others) that are not part of
Cleaver-Brooks’ scope of supply. In either case, the Cleaver-Brooks authorized representative should be
consulted for project specifics.
These are the options that are available for the CFLC boiler from Cleaver-Brooks:
A. Condensate neutralization tank assembly - consists of neutralizing media, filter, and PVC
condensate holding tank. This assembly is further described in Chapter 2.
B. Direct vent combustion air adapter kit
C. Outdoor temperature sensor for outdoor reset, frost protection, and warm weather shutdown
D. Header temperature sensor for multiple boiler Lead/Lag operation
E. Alarm Horn for safety shutdown
F. Relays for output signal for burner on, fuel valve open
G. Stack Thermometer
H. Stack temperature limit-sensor
I. Auto air vent
J. Boiler drain valve
K. Gas pressure relief valve
L. Gas pressure gauge
M. Water isolation valves
N. Hydronic circulating pumps
O. Seismic anchoring provisions
For options not listed, consult your authorized CB representative.
To Next Page
Loading...
