ii
Do not use this boiler if any part has been under
water. Immediately call your Cleaver-Brooks ser-
vice representative to inspect the boiler and to re-
place any part of the control system and any gas
control which has been under water.
!
DANGER
WARNING
!
DANGER
WARNING
If the information in this manual is not fol-
lowed exactly, a fire or explosion may re-
sult causing property damage, personal
injury or loss of life.
— Do not store or use gasoline or other
flammable vapors and liquids in the vicin-
ity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
— Installation and service must be performed by
a qualified Cleaver-Brooks, service agency or the
gas supplier.
Improper installation, adjustment, ser-
vice, or maintenance can cause equip-
ment damage, personal injury, or death.
Refer to the Operation and Maintenance
manual provided with the boiler. Installa-
tion and service must be performed by a
qualified Cleaver-Brooks service provid-
!
DANGER
WARNING
!
DANGER
WARNING
Be sure the fuel supply which the boiler
was designed to operate on is the same
type as specified on the boiler name
plate.
!
DANGER
WARNING
Should overheating occur or the gas sup-
ply valve fail to shut off, do not turn off or
disconnect the electrical supply to the
boiler. Instead turn off the gas supply at a
location external to the boiler.
!
DANGER
WARNING
To minimize the possibility of serious personal in-
jury, fire or damage to the equipment, never vio-
late the following safety rules.
— Always keep the area around the boiler free of
combustible materials, gasoline, and other flam-
mable liquids and vapors
— Never cover the boiler, lean anything against it,
stand on it, or in any way block the flow of fresh
air to the boiler.
This manual must be maintained in legible condi-
tion and kept adjacent to the boiler or in a safe
place for future reference. Contact your local
Cleaver-Brooks representative if additional manu-
als are required.
Notice
Where required by the authority having jurisdic-
tion, the installation must conform to the Standard
for Controls and Safety Devices for Automatically
Fired Boilers, ANSI/ASME CSD-1.
Notice
The boiler and its individual shutoff valve must be
disconnected from the gas supply piping system
during any pressure testing of that system at test
pressures in excess of 1/2 psi (3.5 kPa).
!
DANGER
WARNING
The installation must conform to the requirements
of the authority having jurisdiction or, in the ab-
sence of such requirements, to UL 795 Commer-
cial-Industrial Gas Heating Equipment and/or the
National Fuel Gas Code, ANSI Z223.1
!
DANGER
WARNING
To Next Page
Loading...