Appendix D Falcon Alert, Hold, Lockout Codes
D-9
Table D -2 Fa l c on Al e r t s
Code Description
0 None (No alert)
1 Alert PCB was restored from factory defaults
2 Safety configuration parameters were restored from factory defaults
3 Configuration parameters were restored from factory defaults
4 Invalid Factory Invisibility PCB was detected
5 Invalid Factory Range PCB was detected
6 Invalid range PCB record has been dropped
7 EEPROM lockout history was initialized
8 Switched application annunciation data blocks
9 Switched application configuration data blocks
10 Configuration was restored from factory defaults
11 Backup configuration settings was restored from active configuration
12 Annunciation configuration was restored from factory defaults
13 Annunciation configuration was restored from backup
14 Safety group verification table was restored from factory defaults
15 Safety group verification table was updated
16 Invalid Parameter PCB was detected
17 Invalid Range PCB was detected
18 Alarm silence time exceeded maximum
19 Invalid safety group verification table was detected
20 Backdoor password could not be determined
21 Invalid safety group verification table was not accepted
22 CRC errors were found in application configuration data blocks
23 Backup Alert PCB was restored from active one
24 RESERVED
25 Lead Lag operation switch was turned OFF
26 Lead Lag operation switch was turned ON
27 Safety processor was reset
28 Application processor was reset
29 Burner switch was turned OFF
30 Burner switch was turned ON
31 Program Module (PM) was inserted into socket
32 Program Module (PM) was removed from socket
33 Alert PCB was configured
34 Parameter PCB was configured
35 Range PCB was configured
36 Program Module (PM) incompatible with product was inserted into socket
37 Program Module application parameter revision differs from application processor
38 Program Module safety parameter revision differs from safety processor
To Next Page
Loading...
