ID-DCU-MARINE-2.2.2, ©ComAp – June 2015 - 122 -
ID-DCU-MARINE-2.2.2.pdf
How to check the serial number and software revision?
Hold down the Enter and the press Page. On the display you can see Controller INFO screen for 10
seconds:
Controller name (see Basic Settings group)
Controller serial number (8 characters number)
SW version: the first is the firmware version number, the second is configuration table number.
Application: ID
Branch: InteliDrive
Hint:
Only in MEASUREMENT screen.
How to change the display backlight intensity?
Press Enter and or at the same time to adjust the best display backlight.
Hint:
Only in INFO screen.
How to change controller language?
Press Page to go to Language screen. Select language or a press Page to confirm selection and exit
window.
How to find active alarms?
Active alarm list and J1939 alarm list are the last two screens in the MEASUREMENT menu.
Select MEASUREMENT menu. Press and you will see the list of all active alarms with the number of
alarms at the top-right corner. Inverted alarms are still active. Non-inverted alarms are not active, but not yet
confirmed.
Press Fault reset accepts alarms of active (visible screen). Non-active alarms immediately disappear from
the list.
Active alarm list appears on the screen when a new alarm comes up and Main MEASUREMENT screen is
active.
Hint:
Alarm list does not activate when you are reviewing the values, parameters or history.
The Fault reset button is inactive when controller screen is switched to any other than Alarm list or ECU
Alarm list.
To Next Page
Loading...
Need help?
General
