ComAp InteliDrive DCU Marine Reference Guide

ID-DCU-MARINE-2.2.2, ©ComAp – June 2015 - 33 -
ID-DCU-MARINE-2.2.2.pdf
I-LB+ Communication Bridge
I-LB+ is communication modules for communication with all devices connected to CAN2 bus. I-LB+ is
successors of the IG-MU unit designed to be used with ComAp controllers. It therefore provides additional
communication port and higher communication speed. Speed for direct/modem connection can be up to
57600 bps (IG-MU only 19200 bps). I-LB+ can be connected with PC via USB, RS232 or RS485.
For more details see Accessory Modules for IG-NT, IS-NT and ID-DCU document on ComAp web pages
http://www.comap.cz/.
IG-IB Internet bridge
Internet interface unit for single or multiple engines.
95 mm
(3,7´´)
43 mm
(1,7´´)
96 mm (3,8´´)
It is recommended to use IG-IB firmware version 2.0
IG-IB unit is DIN 35 mm rail mounted.
InternetBridge-NT
InternetBridge-NT is a communication module that allows connection of a single controller as well as whole
site to the Internet or Local area network. The connection to the Internet can be via built-in cellular modem
supporting 2G and 3G networks or Ethernet cable.
Hint:
Just CAN2 connection between InteliDrive DCU Marine and InternetBridge-NT device is possible. RS485 as
well as RS232 InternetBridge-NT interface cannot be used for interconnection with InteliDrive DCU Marine
controllers.

ComAp InteliDrive DCU Marine Specifications

General

Brand	ComAp
Model	InteliDrive DCU Marine
Category	Controller
Language	English