ComAp InteliDrive DCU Marine - Corresponding Documentation; Standard Firmware Vs. Firmware Supporting Websupervisor

ID-DCU-MARINE-2.2.2, ©ComAp – June 2015 - 9 -
ID-DCU-MARINE-2.2.2.pdf
Corresponding documentation
1
DriveConfig-3.3.pdf (September 2013)
PC configuration software
2
Intelimonitor-3.0-Reference Guide.pdf (June 2013)
PC monitoring software
3
ID-DCU-Industrial-2.8.pdf (Feb 2011)
ID-DCU Industrial branch
4
InteliCommunicationGuide – April 06.pdf (April 2006)
Communication guide
5
IGS-NT, ID-DCU-Accessory Modules.pdf (June 2013)
Extension modules for ID-DCU, IGS-NT
gen-set or engine controllers
Standard firmware vs. firmware supporting WebSupervisor
There are two firmware versions for ID-DCU Marine controller starting from version 2.2. Firmware and
application files labeled by “W” are intended to use together with WebSupervisor ComAp tool. This firmware
version has limited functionality in comparison with standard version, see table below.
Function
Standard version
(ID-DCU-MARINE-2.2.mhx)
WebSupervisor version
(ID-DCU-MARINE-W-2.2.mhx)
WebSupervisor support
NO
YES
J1587 support
YES
NO
Alarm list reading in text form via
MODBUS (registers 46669 .. 47068)
YES
NO
History reading via MODBUS (registers
46357, 46493 .. 46541, 46543 .. 46667)
YES
NO
All other ID-DCU Marine functions
YES
YES
See AirGate and WebSupervisor basic description in this Reference Guide.