ID-DCU-MARINE-2.2.2, ©ComAp – June 2015 - 105 -
ID-DCU-MARINE-2.2.2.pdf
5thRemPan [ ENABLE, DISABLE ]
The parameter switches the address for a 5
th
I-RD-CAN-ID-DCU-MARINE display, the fifth I-RD-CAN-ID-
DCU-MARINE display occupies a modem address if ENABLE is set. ENABLE is a default value.
LightTimeOff [ min ]
Timeout for ID display backlight automatic switch off. Zero setting disables display backlight switch off.
Backlight is automatically switched on after any key press or Alarm activation.
Step: 1 min
Range: 0 – 250 min
Hint:
LightTimerOff setpoint influences the Remote panel not master controller when changed on Remote panel.
MODBUS [ 9600, 19200, 38400 ]
Modbus interface baud rate speed setting.
Timer ON, Timer OFF [ hh:mm:ss ]
See following Timer Repeat description.
Timer Repeat [ Never, Mon-Fri, Mon-Sat, Mon-Sun, Sat-Sun ]
Logical binary output Timer Active is closed when actual time is over the Timer ON and opened when actual
time is over Timer OFF. The function depends on Timer Repeat settings. The output is closed when
controller is switched On and Timer settings corresponds to closed state.
Engine params
Starting RPM [ RPM ]
“Firing” speed when controller stops cranking = one of the engine running indications.
Step: 1 RPM
Range: 30 – 1500 RPM
Hint:
Under speed limit is fix 30 RPM.
Starting POil [ Bar ]
Oil pressure limit when controller stops cranking = one of the engine running indications.
To activate this function any Analog input must be configured to Analog logical input Oil press.
Step: 0,1 bar
Range: 0 – 10,0 bar
Hint:
Step, Range and dimension depend on corresponding Analog input sensor characteristic.
To Next Page
Loading...
Need help?
General
