User's Manual
125
●
Select the
DHCP
checkbox, you do not need to enter the IP address information,
because the system will allocate one IP address to the remote device.
●
Select the
STATIC
checkbox, you need to enter the IP address, subnet mast, default
gateway, and incremental value. The system will allocate the IP address to the remote
devices by progressively increasing the last part of the IP address when initializing
devices in batches.
When configuring IP address for multiple remote devices which were not in the same
network segment, these remote devices will belong to the same network segment after
configuration.
Step 8 Click
Next
.
The initializing is started.
Figure 5-79 Initialization finished
Step 9 Click
Finished
to complete the settings.
5.6.1.2 Adding Remote Devices Automatically
Procedure
Step 1 On the
Registration
page, click
Device Search
The devices found are displayed.