User's Manual
240
Parameter Description
More Setting
●
Show Message: Select the
Show Message
checkbox to enable
a pop-up message in your local host PC.
●
Buzzer: Select the checkbox to activate a buzzer noise at the
Device.
●
Video Matrix: Select the checkbox to enable the function.
When an alarm event occurs, the video output port outputs
the settings configured in
Main Menu
>
DISPLAY
>
Tour
.
This function is available on select models.
●
Send Email: Enable the system to send an email notification
when an alarm event occurs.
To use this function, make sure the email function is enabled
in
Main Menu
>
NETWORK
>
Email
.
●
Log: Select the checkbox to enable the Device to record a local
alarm log.
●
Extra screen: Select the checkbox to enable the function.
When an alarm event occurs, the extra screen outputs the
settings configured in
Main Menu
>
DISPLAY
>
Tour
>
Sub
Screen
.
●
This function is available on select models.
●
To use this function, extra screen shall be enabled.
Step 4 Click
Save
to save the settings.
5.12.2.4.2 Configuring Alarm Settings for Humidity Data
You can configure the alarm event by setting the humidity data.
Procedure
Step 1 On the home page, select
IoT
>
Management
>
Temperature/Humidity
.