User's Manual
56
5.1.3.3 Using Reset Button on the Mainboard
Background Information
You can always use the reset button on the mainboard to reset the Device to the factory default.
The reset button is available on select models.
Procedure
Step 1 Disconnect the Device from power source, and then remove the cover panel. For details
about removing the cover panel, see "2.2 Installing HDD".
Step 2 Find the reset button on the mainboard, and then press and hold the reset button for 5
seconds to 10 seconds.
Figure 5-16 Reset button
Step 3 Restart the Device.
After the Device is rebooted, the settings have been restored to the factory default. You
can start resetting the password.
5.1.4 Setting Up with the Startup Wizard
5.1.4.1 Entering Startup Wizard
The Startup Wizard helps you configure the basic settings to set up the Device.
After you have initialized the Device, the
Startup Wizard
page is displayed.
To Next Page
Loading...
Need help?
General
