User's Manual
176
Parameter Description
Alarm-out Port
Click
Setting
to configure the parameters.
●
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
●
External Alarm: Enable alarm activation through the connected
alarm box.
●
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Show Message
Select the
Show Message
checkbox to enable a pop-up message in your
local host PC.
Send Email
Select the
Send Email
checkbox to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu
>
NETWORK
>
Email
.
Buzzer Select the checkbox to activate a buzzer noise at the Device.
Log Select the checkbox to enable the Device to record a local alarm log.
Post Record
Continue to record for some time after the alarm is ended. The value
ranges from 10 seconds to 300 seconds.
Alarm Tone
Select to enable audio broadcast/alarm tones in response to a network
alarm event.
Step 3 Click
Apply
to complete the settings.
5.10.6 Configuring Disarming
You can disarm all alarm linkage actions as needed.
Procedure
Step 1 Select
Main Menu
>
ALARM
>
Disarming
.
Step 2 Click to enable disarming.
To Next Page
Loading...
Need help?
General
