User's Manual
259
firstly you need to obtain the username and password from the Internet Service Provider.
Procedure
Step 1 Select
Main Menu
>
NETWORK
>
PPPoE
.
Figure 5-223 PPPoE
Step 2 Enable the PPPoE function.
Step 3 In the
Username
box and
Password
box, enter the username and password accordingly
provided by the Internet Service Provider.
Step 4 Click
Apply
to complete the settings.
The system pops up a message to indicate the successfully saved. The IP address appears
on the PPPoE page. You can use this IP address to access the Device.
When the PPPoE function is enabled, the IP address on the
TCP/IP
page cannot be
modified.
5.15.1.6 Configuring DDNS Settings
When the IP address of the Device changes frequently, the DDNS function can dynamically refresh
the correspondence between the domain on DNS and the IP address, ensuring you access the
Device by using the domain.
Prerequisites
Confirm if the Device supports the DDNS Type and log in the website provided by the DDNS service
provider to register the information such as domain from PC located in the WAN.
After you have registered and logged in the DDNS website successfully, you can view the
information of all the connected devices under this username.