User's Manual
164
Figure 5-118 Warning light
Step 2 Configure the settings for the warning light parameters.
Table 5-37 Warning light parameters
Parameter Description
Channel
In the
Channel
list, select a channel that is connected to a warning
light camera.
Delay
Set a length of time for the Device to delay turning off alarm after
the alarm is cancelled. The value ranges from 5 seconds to 30
seconds, and the default value is 5 seconds.
Mode Set the alarm mode of warning light to be
Always on
or
Flicker
.
Flicker Frequency
When setting the alarm mode of warning light to be
Flash
, you can
select the flash frequency from
Low
,
Middle
, and
High
.
Step 3 Click
Apply
to complete the settings.
5.10.3.3 Configuring Siren
When the motion detection alarm is activated, the system links the camera to generate sound alarm.
To use this function, connect at least one camera that supports audio function.
Procedure
Step 1 Select
Main Menu
>
ALARM
>
Alarm-out Port
>
Siren
.