User's Manual
61
Figure 5-20 TCP/IP
Step 2 Configure the settings for network parameters.
Table 5-5 Network parameters
Parameter Description
IP Version
In the
IP Version
list, you can select
IPv4
or
IPv6
. Both versions are
supported for access.
MAC Address Displays the MAC address of the Device.
DHCP
Enable the DHCP function. The IP address, subnet mask and default
gateway are not available for configuration once DHCP is enabled.
●
If DHCP is effective, the obtained information will display in the
IP Address
box,
Subnet Mask
box and
Default Gateway
box.
If not, all values show 0.0.0.0.
●
If you want manually configure the IP information, disable the
DHCP function first.
●
If PPPoE connection is successful, the IP address, subnet mask,
default gateway, and DHCP are not available for configuration.
IP Address Enter the IP address and configure the corresponding subnet mask
and default gateway.
IP address and default gateway must be in the same network
segment.
Subnet Mask
Default Gateway
DNS DHCP Enable the DHCP function to get the DNS address from router.
Preferred DNS
In the
Preferred DNS
box, enter the IP address of DNS.
Alternate DNS In the
Alternate DNS
box, enter the IP address of alternate DNS.
To Next Page
Loading...
Need help?
General
