INPUT
PROGRAM
RESPONSE
NEW LINE
Immediately loads software from the automatic program load device
(default device). Its code appears in the brackets.
Device code followed I
Loads software from the device specified by the new code.
by NEW LINE
The following codes are commonly used for tape and disk subsystems.
Code
Device Type
22
Primary tape subsystem
62
Secondary tape subsystem
24
Primary Winchester disk subsystem
64
Secondary Winchester disk subsystem
27
Primary removal pack disk subsystem
67
Secondary removable pack disk subsystem
Option 4
Change Default Device
Enter new default device code [22]:
INPUT
PROGRAM RESPONSE
NEW LINE
Leaves the default device code, which is displayed in brackets, unchanged.
(The default device code specifies the automatic program load device for
the next power-up.)
Device code followed J
Accepts the new code as the default device code. This code specifies the
by NEW LINE
device for automatic program loading on the subsequent power-ups.
The following codes are commonly used for tape and disk subsystems.
Code
Device Type
22
Primary tape subsystem
62
Secondary tape subsystem
24
Primary Winchester disk subsystem
64
Secondary Winchester disk subsystem
27
Primary removable pack disk subsystem
67
Secondary removable pack disk subsystem
DGC CONFIDENTIAL - INTERNAL USE ONLY
4-13
043-003621
To Next Page
Loading...