5. User interface AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
62 Operating Instructions (Version 03/2018)
The following table lists the available functions in the "Setup" menu and provides a short
description. A detailed explanation can be found in the indicated section in the column "See
section".
Function Description See section
System control functions
[Units] Select the unit for the user temperature. 5.8.1.1
[Language] Select a language for the user interface. 5.8.1.2
[Date/time] Current date and time in the firing furnace
control.
5.8.1.3
[Screen setting] Determines how long to wait until the
screensaver is activated after an entry is
made.
5.8.1.4
[Network] Network settings for the firing furnace. 5.8.1.5
[General code] Access levels for the firing furnace. 5.8.1.6
Settings for the firing furnace
[Furnace ID] Enter the furnace ID. 5.8.2.1
[Acoustic signal] Set the acoustic signal at the end of the
program.
5.8.2.2
[Heating settings] Defines the maximum temperature rise
rates and power consumption.
5.8.2.3
[Lift settings] Specifies if a warning is displayed before
opening the lift when the firing chamber is
hot.
5.8.2.4
Maintenance programs
[Drying] Runs a program for drying the firing
furnace.
5.8.3.1
[Check program] Executes the check program to check the
function of the most important components.
5.8.3.2
[Oxidation] Runs the oxidation program. 5.8.3.3
[Temperature calibration] Calibrates the temperature and sets the
CCF value (calibration factor).
5.8.3.4
To Next Page
Loading...