HARDWARE S ETUP
VF8 DELTA/DELTA XL/KAPPA 14-9
Transducer cables plug into adapter blocks on the back of the pod and can be mounted
on the front panel. Slide the transducer into the slot nearest the associated pod
connector. With the MPod – QuadHemo, the transducers are attached to intermediate
cables which are permanently fastened to the back of the MPod.
To connect the hemodynamic pod to the monitor
1. Plug one end of the cable into the appropriate monitor connector.
2. Connect the other end of the cable into the hemodynamic pod connection port.
Hemo4 Pod
1
Transducer
2
Transducer cable
3
Adapter blocks
Rear View
Side View
1
Hemo2, Hemo4 or MPod – Quad Hemo connector (second
connector optional on Delta) or Picco pod connector
2
HemoMed connector
Kappa
Delta/Delta XL
To Next Page
Loading...
