25-4 DELTA/DELTA XL/KAPPA VF8
25 B
ISPECTRAL INDEX (BISX) MONITORING
Connecting the BISx Pod
Connect the BISx pod to the Delta/Delta XL/Kappa monitor by plugging the PodCom
cable into the PodCom connector in the monitor (see illustration below). Plug the
sensor into the sensor cable. Attach the BISx pod to an IV pole, bed rail, or clip it to a
bedsheet.
NOTE:
An automatic sensor impedance check is initiated each time a BIS sensor is
connected to the sensor cable.
All signal status messages and alarms are suppressed for 60 seconds after a
sensor impedance check has ended. This allows time for signal quality to
recover.
1 Sensor cable
2 BISx pod
3 BIS sensor
4 PodCom connector
5 PodCom cable
Kappa (Front View)
Delta/Delta XL (Left View)
To Next Page
Loading...
