TRANSFER MEMORY MENU
Eco Manual
211
Load an IR Device/Save an IR Device
Perhaps you and a friend each buy the same TV. Your friend adds the TV and gets the new TV
signals programmed into her Vantage Lite before you do. She can save her programming as an
.mti file and give it to you to load into your Vantage Lite so you don't have to do the
programming yourself.
Save an IR Device
1. Make sure your USB flash drive or SD card is plugged into your communication aid.
2. Open the
TRANSFER MEMORY MENUI in the Toolbox.
3. Select
Save an IR Device.
4. You see a page that contains all your IR Devices. Select the one you want to save.
5. You see the "Save" window from your flash drive or your SD card. Your IR device is ready
to be saved as an .mti file. If you want to change the name of the file, do so now.
DO NOT change the .mti part of the name.
6. Select
Save.
7. Activate
OK to exit.
To Load an IR Device
1. Make sure your USB flash drive or Secure Digital card is plugged into your communication
aid.
2. Open the
TRANSFER MEMORY MENU in the Toolbox.
3. Select
Load an IR device.
4. If you want the device to replace one that is already in your device, select
YES and then
select the device you want to replace.
If you do not want to replace an existing IR device, select
NO.
5. Select the .mti file that contains the device command and signals you want to load and then
select
Open.
6. Activate
OK to exit.
To Next Page
Loading...