SETTING UP YOUR DEVICE
ECO Manual
48
When you turn Predictive Selection On, your device highlights only those icons where
messages are stored. These highlighted icons are the only keys on the keyboard that will
produce a response.
You can change the color of the non-active keys to grey or white. Go to the FEEDBACK
MENU, Icon Prediction and select Grey or White. Grey allows you to see the shadow of the
icon on the key; white turns the entire key white so it looks blank. But if you try to select a grey
or white key, nothing will happen.
Note: Icon Prediction alone allows you to press grey or white keys. The key's icon will
appear in the Icon display area but no message will be spoken. Icon Prediction will work
whether Predictive Selection is On or not.
1 Switch Scanning Methods
When you select 1 Switch as an access method, you see a screen that contains a number of ways
to scan with one switch. Below are brief descriptions of the technique terms.
Plug a single switch (or a dual switch using only the SELECT side) in either the SWITCH A
or SWITCH B connector on the left side panel of your device.
If you are unsure how you want to use the 1 Switch method, we highly recommend that you
try out the different 1-switch techniques to find the one that suits you best.
Auto Scan
Your device automatically scans the keyboard.
Hold Scan
You must press and hold your switch to scan the keyboard.
Step Scan
You must activate your switch each time you want to move to a new position on the keyboard.
Linear Scan
This allows you to step through the keys on your overlay moving from left to right across the
rows or from top to bottom down each column. You must activate your switch to move the scan.
To Next Page
Loading...