Eco 14 - Completely Erase the Contents of a Key; Link an Icon Sequence to an Already Created Page

USING THE CORE VOCABULARY OVERLAY
ECO Manual
105
Completely Erase the Contents of a Key
To completely erase the entire contents of a key in an Activity or Page, go to the Activity or
Page.
Select the SET-UP key, then select the icon key you want.
Select the Clear Key Contents key.
Select OK when you are finished.
If you decide you didn't really want to erase the key, select Cancel instead of OK.
Link an Icon Sequence to an already Created Page
If, instead of programming a message under an icon sequence, you want to link the sequence to a
Page you have already created, follow the steps below.
1. Select STORE CORE in the Toolbox.
2. Select the icon sequence you want to use, then select OK.
3. Select Computer Speech
4. Select Spell Message…
5. Select PAGE LINK on the spelling overlay.