INTERNAL COMPUTER
Eco Manual
239
About Teaching Remote Control Signals to your Device
In the
REMOTES Activity you will find pre-stored Pages with icons and commands that
represent your remote control signals. For all appliances except the phones, the IR car and the
X10, you will have to teach your ECO the signals you want it to use. The phones, IR car and X-
10 already have their signals stored in your device.
Before you begin to store any signals, make sure the remote control you are going to use is at
hand. During the signal storing process, your device will tell you to aim your remote control at
the IR window and then to tap the button on the remote that will send the signal you want your
device to learn.
To store signals you will use the
IR SETUP MENU in the Toolbox. When you store signals
using this menu, they are automatically stored on the correct
REMOTES Activity page for later
use.
Remember, the IR window is on the back top of your device. Hold the remote control 6-8" away
from the left corner of the IR window. Point the infrared area of the remote at your device's IR
window and press the function button on the remote, for example, "Power". You will hear a
small beep when the device accepts the signal.
Important!
When you have finished storing all the remote control signals that you want to use, we highly
recommend that you perform a memory transfer and save your device's memory to a USB flash
drive or the internal hard drive. Should your device ever lose its memory, all your remote control
signals will be lost and you will have to reprogram everything.
Use the "Save Entire Device" option, not the "Save One Area" option. The signals will not be
saved unless you select
Save Entire Device.
To Next Page
Loading...