APPENDIX I: IRR ADVANCED SETUP MENU/TROUBLESHOOTING
Eco Manual
313
Appendix I: The ADVANCED INFRARED SETUP MENU
(IRR) and IRR Troubleshooting
To open the
Advanced Infrared Setup Menu:
1. Go to the Toolbox.
2. Open the
OUTPUT MENU.
3. Set Output Method to Infrared
4. Select the Advanced Settings option. This opens the ADVANCED INFRARED SETUP
MENU.
ECO Unit Number = >1<
The default is Number 1. In multiple device situations, you can choose to be Unit 1, 2, 3 or 4.
EZ Phone Unit Number = >1<
The default is Number 1. In multiple device situations, you can choose to be Unit 1, 2, 3 or 4.
EZ Phone Baud = >1200<
The default is 1200. You can change to 300 if necessary.
IRR Unit Number = >1<
The default is Number 1. In multiple device situations, you can choose to be Unit 1 or 2.
IR Receiver Protocol = >PACKET<
The default is PACKET protocol. You can choose PIPELINE protocol, if necessary. See page
401 for protocol information.
Infrared Troubleshooting
Single Device, EZ Phone and IRR Use or Multiple Devices, EZ Phones and IRR use
The chances are that you will be the only person using your communication aid with an EZ
Phone or a computer and the IRR. However, there may be situations, such as a lab or therapy
facility, where there may be two or more devices, EZ Phones, IRRs and computers all in the
same room, receiving the same signals at the same time.
If you are in a situation where multiple devices are in use, you have to tell your communication
aid which devices it is going to talk to. You do this by assigning the same unit number to your
communication aid, the EZ Phone and the IRR.
To Next Page
Loading...