INTERNAL COMPUTER
Eco Manual
242
10. You can exit by activating OK twice, or you can select another appliance and continue to
teach signals.
When you have finished storing signals for an appliance, go to the remote control page for that
appliance and explore what you have done!
1. Exit the
IR SETUP MENU.
2. In the Toolbox, activate
GO TO CORE.
3. Activate the
REMOTES key in your Activity Row. This may be by itself in
the row or stored under the
DEVICE or MY TOOLS key depending on the
overlay you are using.
4. Select the remote page you want and see if your signals work.
Remember to save your device memory after you have taught the remote control signals. See
the
TRANSFER MEMORY MENU chapter.
Helpful Tip! When you have successfully stored the signals for a device, a small dot will
appear beside the name of that device on the main screen of the IR SET-UP MENU. A dot will
also appear beside the functions that have signals stored for them. You will see those when you
are using the function screen of the IR SETUP MENU.
Add a New Device to the IR SETUP MENU
Perhaps you buy a new remote control appliance, or maybe you want to program signals for
other TVs in your house. You will have to add the new devices to your
IR SET UP MENU.
For this example, let's say you want to add a TV in your bedroom.
To Add a Device to the IR SETUP MENU
1. Go to the Toolbox and open the IR SETUP MENU.
To Next Page
Loading...