Eco 14 - Using an External Computer with a USB Cable; Using an External Computer with the PRC Bluetooth Wireless Adapter

INTERNAL COMPUTER
Eco Manual
273
Using an External Computer with a USB Cable
You can connect your ECO to an IBM or Mac by using a USB cable.
Connect one end of the cable to the square USB port on the right side of your ECO. Connect the
other end to the USB port on your computer (this may be on the front of the computer or in back,
or both). If your computer and ECO are not already on, turn them on now.
1. Go to the ECO Toolbox and open the OUTPUT MENU.
2. Set
Output to ON.
3. Set
Output Destination to EXTERNAL.
4. Set
Output Method to USB
5. Set
Host Computer Type to either IBM or Mac, depending on what kind of computer you
are using.
6. Select
OK to exit the menu.
Using an External Computer with the PRC Bluetooth
Wireless Adapter
IMPORTANT NOTE!
Before you plug your wireless adapter into your computer:
Notice that the wireless adapter has a PRC label on one side and a label with a white circle and
an arrow pointing down on the other. The circle label covers a small switch called the "pair
button".
You will have to press this white circle during the set-up process. Depending on where the
USB ports are on your computer, it may be difficult to reach the circle and also reach your ECO.
You may want to ask someone to help you.
1. Plug the Bluetooth wireless adapter into the USB port on your computer. Remember
where the white circle is on the adapter. The LED on the adapter may flash for a moment
when you plug it in.
2. On your ECO, got to the Toolbox and open the
OUTPUT MENU.
3. Set
Output to ON.
4. Set
Output Destination to EXTERNAL