GETTING ACQUAINTED WITH YOUR ECO
ECO Manual
22
After ten minutes of dimmed backlight and no key activations, the screen goes dark. Activate
any key or switch to bring it back.
We recommend that you leave Auto Power Down set to On. You can select the amount of
time you want to use if 2 minutes is too fast for you.
If you change Auto Power Down to Off, the device will never turn Off unless you press the
ON/OFF button on the top of the case or activate the POWER OFF key in the Toolbox. If you
forget that you turned Auto Power Down to Off and the device never goes Off, the batteries will
eventually go dead.
Note: If you are using a headpointer and your device turns Off, you can activate a
switch to turn it back on. The switch must be plugged into a Switch port on your device.
Use POWER OFF or the ON/OFF button to properly shut down your device.
Troubleshooting Tip: If your device does not turn off or come back on as you expect it
to: Press and hold the ON/OFF button for ten seconds. The device should turn on (or off).
When your device turns off, it saves any storing and/or programming that you have done
up to that point. If you are doing a lot of storing/programming —perhaps setting up an
overlay—make sure the device turns Off periodically so that your work is saved.
To Next Page
Loading...