APPENDIX I: IRR ADVANCED SETUP MENU/TROUBLESHOOTING
Eco Manual
315
IRR or set it so that its IR window is at an angle to the IRR. The signal will go through but it
will not overpower the IRR.
When you use your communication aid with a computer and an IRR, you set (among other
things) the
Output option to On and the Output Destination to IRR in the OUTPUT MENU.
If you use your device with these settings when the IRR is not available (in another room or
blocked in some way), you will get an error message that says the device is busy sending IR data.
Either go where the IRR is or check to make sure the IRR is not blocked. If you don't want to
send signals at all, go to the
OUTPUT MENU and turn the Output to Off.
To Next Page
Loading...