APPENDIX L: TROUBLESHOOTING
ECO Manual
337
If the batteries have gone completely dead, plug in your charger. The LED on the left in
the headpointing IR window will begin to flash rapidly, indicating the batteries are charging
Battery Disposal:
If the batteries in your device need to be replaced, dispose of the old batteries properly.
Follow the regulations of your community, state or country for the disposal of batteries.
If the wrong keys are being activated:
Recalibrate the display screen. See Appendix B for more information
If you activate a key or keys and your device makes a "raspberry" noise:
A Dynamic Activity is stored under the key(s) but it is hidden. Open the DYNAMIC
ACTIVITY MENU
to see if something is stored at this location. If you see the sequence but the
"Activity" is listed as "unknown" you may have deleted the Activity at some other time. You
must either
add the Activity, or delete the sequence by activating the Delete Dynamic Activity
key in the DYNAMIC ACTIVITY MENU and then selecting the key or sequence you stored
the activity under.
Auto-repeat won't work when you are using "Activate Key When = Released":
The key is selected after you have released it and after the Release Time has expired. If you
have set a long Release Time you must wait for it to expire before the key will begin to repeat.
About High-Efficiency Fluorescent Lights and the Use of Infrared:
There is a compatibility problem between many infrared controls and high-efficiency fluorescent
lights.
If you are using your device in a room that has high-efficiency fluorescent lighting, the infrared,
including headpointing, computer access, remote control commands, etc., will not work. Turn
the lights off and the IR will work fine.
Never immerse your device in water!
Important Note! Do not spray anything directly on the device. This will loosen labels
and corrode connectors.
Instead, spray a cloth and use the dampened cloth to wipe the device.
To Next Page
Loading...