Emerson CSI 2140

2.
Press and hold the power key
to turn the analyzer on.
The Home screen appears when you turn on the analyzer. The time and date are set
to a default value.
3.
To set the time and date, press Home > ALT > F3 Set Time.
2.5 Use the stand
1. To put the stand in the upright position, grab the stand and pull up until the stand
locks.
2. To release the stand, place the analyzer face down, grab the base of the stand, and
gently pull.
The lock releases, and you can push the stand toward the analyzer.
Release the standFigure 2-3:
2.6 Attach the shoulder strap
1. Press and hold the button on the strap connector, and insert it into the connectors
on the sides of the analyzer or the CSI 2140 Four-Channel Input Adapter, if attached.
2.
To release the strap, press and hold the button on the connector and then pull.
Introduction to the analyzer
MHM-97432 Rev 7 9