A.4 Connecting to a computer
Requirements
Connections/output USB 2.0, 100M Ethernet
Compatible software AMS Machinery Manager version 5.6 or greater. Refer to
www.assetweb.com/mhm under AMS Machinery Manager software for
the most current operating requirements.
A.5 Waste Electrical and Electronic Equipment
Marking for the Waste of Electrical and Electronic Equipment in accordance with Article II
(2) of Directive 2012/19/EU (WEEE). The European Directive 2012/19/EU requires marking:
• That applies to electrical and electronic equipment falling under Annex 1 Category 9
of Directive 2012/19/EU.
• That serves to clearly identify the producer of the equipment and that the
equipment has been put on the market after 13 August 2005.
• That the crossed out wheeled bin alerts the end-user to dispose this equipment via
the special recycling procedure for electrical and electronic equipment that is
applicable in the country of use.
• The shown marking is attached to the product and identifies the product to fall
within the scope of this directive.
A.6 FCC
CAUTION!
Changes or modifications not expressly approved by Computational Systems Incorporated
could void the user's authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Technical specifications
MHM-97432 Rev 7 375
To Next Page
Loading...
Need help?
General
