Prerequisites
On the analyzer, press Home > ALT > F2 General Setup > F6 Set Print Mode and ensure the
default print mode is set to Store as BMP on CARD or Store as JPG on CARD.
Procedure
1.
Display your plot in Analyze.
You can press F2 Review Data on the Analyze main menu, or collect data and view the
plot.
2. Press F7 Print Plot.
3. Enter up to 8 characters for a file name.
4. Press Enter.
The analyzer begins creating and saving the file to the memory card. The progress is
displayed on the screen.
6.16 Reset Analyze defaults
The analyzer resets the measurements, sensor, and tachometers setups and deletes any
unsaved data.
Procedure
1. From the Analyze main menu, press ALT > F12 Reset Analyze.
2. Press Enter.
Analyze and Advanced Analyze
160 MHM-97432 Rev 7
To Next Page
Loading...
Need help?
General
