Memory card partially inserted into the analyzerFigure 2-12:
4. To remove the memory card, push the memory card into the memory card slot until
it clicks and releases.
2.16 Bluetooth
If your analyzer supports Bluetooth
®
communication, you can listen to live vibration
signals from an accelerometer (with the audio not stored) and use the Laser Alignment
Application. If your analyzer supports Bluetooth, a Bluetooth LED is on the top of analyzer.
See Section 2.3. If your analyzer does not support Bluetooth, the Bluetooth options in the
Communication Setup, Route, and Analyze screens are unavailable.
To use Bluetooth receivers, headphones, and laser fixtures, enable the Bluetooth radio in
the analyzer and then pair and connect to the Bluetooth device. When the radio in the
analyzer is enabled, the Bluetooth LED on the top of the analyzer turns on and a small
Bluetooth icon appears in the upper corner of the screen. The radio remains on until you
disable it.
Note
For Bluetooth receivers and headphones, you need an A2DP Bluetooth headphone, or an A2DP
Bluetooth receiver and any headphone. You can use the CSI 2130 A646 headphones with the
Bluetooth functionality in the CSI 2140. You need the adapter cable from Emerson and an A2DP
Bluetooth receiver available online or from an electronics store.
To help ensure a good connection, make sure the Bluetooth device is charged and located
within 30 feet of the analyzer. Also, follow the instructions from the manufacturer of your
device. After you pair the device, the analyzer automatically tries to connect to the device.
Introduction to the analyzer
MHM-97432 Rev 7 33
To Next Page
Loading...
Need help?
General
