3. Select a job and press F4 Select Job.
4.
Press F5 Clear Data.
The measurement displays "No Data" on the Current Job screen.
5. Press Enter.
6.2.11 Save an Analyze job to equipment in a route
You can save a job to equipment in a route. When you transfer the job to AMS Machinery
Manager, the data is assigned to that equipment in the database. Use this when you
collect data outside the route. When you select the equipment, the analyzer uses the
equipment ID and description in the corresponding fields in Job Setup.
Procedure
1. From the Analyze main menu, press F9 Job Setup.
2. To switch between internal memory or a memory card, press F1 Change Job > F3
Change Location.
3. Select a job and press F4 Select Job.
4. Press F3 Edit This Job > F1 Route Equip.
5. Use the up and down arrow keys to select a route, and press F4 Select.
6. Use the up and down arrow keys to select the equipment, and press F4 Select.
6.3 Set display parameters
6.3.1 Set the overlap in Analyze
Overlap controls how much each new average overlaps the previous average when taking
a spectra measurement. The higher the overlap percentage, the less newly acquired data is
needed to generate a spectrum. A higher percentage decreases the data collection time.
The default overlap, 67 percent, is acceptable for most situations.
Procedure
1. From the Analyze main menu, press ALT > F4 Set Overlap.
2. Enter a percent between 0 and 99.
The default is 67 percent.
3. Press Enter.
Analyze and Advanced Analyze
112 MHM-97432 Rev 7
To Next Page
Loading...
Need help?
General
