A checkmark appears next to the file.
5.
Press F7 Delete.
6. Press Enter to delete the file, or press Back to cancel.
Move a route or a job file to a memory card or internal
memory
1. Insert a memory card into the analyzer.
2. Press Home > F2 File Utility.
3. Press F8 Mode until F7 displays Move.
4. Press F10 Set Source Card to select the location of the file to move.
The Source and Destination fields change.
5. Select the file to move, and press F9 Select/Unselect File.
A checkmark appears next to the file.
6. Press F7 Move.
The file appears at the new location, and is deleted from the previous location.
2.17.2 Memory Utility
The Memory Utility on the Home ALT2 screen lets you control the internal memory. You can
view detailed information about the internal memory, clean the memory, erase internal
settings, and format disks.
CAUTION!
Use the Memory Utility features only when instructed by technical support. When used
improperly, these options can delete important information.
View detailed information about the internal memory
Use this information to troubleshoot issues with the internal memory.
Procedure
Press Home > ALT > F4 Memory Utility > F2 Detailed Info.
Defragment the internal memory
Defragment the internal memory to optimize memory storage. No data is deleted during
this process.
Introduction to the analyzer
38 MHM-97432 Rev 7
To Next Page
Loading...
Need help?
General
