Operator’s Guide 219
ESC B and ESC b clear all existing vertical tabs. Therefore, to add one
tab, you must include all existing tabs, plus the new one. Use ESC B or
ESC b to set the tabs. Use the Vertical Tab control code, VT, to cause
the printer to tab to each subsequent tab.
ESC / Select Vertical Tab Channel
ASCII:
ESC / (n)
Control:
CTRL
[/ (n)
Decimal:
27 47 (n)
Hexadecimal:
1B 2F (n)
Selects one of eight vertical tab channels as active. All subsequent VT
commands use the channel selected by this command. Valid entries for n
are 0 to 7. The default value is 0.
To Next Page
Loading...
