Epson PowerLite 4100 - Page 272

252 IBM Proprinter Control Commands
ESC S Set Subscript/Superscript
ASCII:
ESC S (n)
Control:
CTRL
[S (n)
Decimal:
27 83 (n)
Hexadecimal:
1B 53 (n)
Prints characters following this control command as subscript or
superscript characters. n specifies either subscript or superscript:
•
n = 1 or 49: Select subscript
•
n = 0 or 48: Select superscript
Subscript or superscript characters are printed at normal height. ESC S
remains in effect until ESC T is received. Multiple ESC S (n) commands
may be sent prior to an ESC T.
Note
: This function works only if Sub/Superscript is enabled from the
configuration menu.
ESC T Cancel Subscript/Superscript
ASCII: ESC T
Control:
CTRL
[T
Decimal: 27 84
Hexadecimal: 1B 54
Cancels subscript/superscript set by ESC S.