Epson TM-T88III

CONFIDENTIAL
Paper roll Character commands ESC &
Ver. 10.01 p. 114
TM-L60II: y = 3
32 ≤ c1 ≤ c2 ≤ 126
0 ≤ x ≤ 12 (Font A (12 × 24))
0 ≤ x ≤ 9 (Font B (9 × 24))
0 ≤ d ≤ 255
k = c2 – c1 + 1
TM-U230, TM-U220, TM-U210, TM-U300A/B:
y = 2
32 ≤ c1 ≤ c2 ≤ 126
0 ≤ x ≤ 12 (Font A (9 × 9))
0 ≤ x ≤ 10 (Font B (7 × 9))
0 ≤ d ≤ 255
k = c2 – c1 + 1
[Default] None
[Printers not featuring this command] TM-P60
[Description] Defines the user-defined character pattern for the specified character codes.
• y specifies the number of bytes in the vertical direction.
• c1 specifies the beginning character code for the definition, and c2 specifies the final code.
• x specifies the number of dots in the horizontal direction from the left.
• d specifies the defined data (column format).
• k indicates the number of defined data. k is an explanation parameter; therefore it does not need to
be transmitted.
[Notes]
■ Character codes from the alphanumeric characters (20H (decimal 32) to 7EH (decimal 126)) can be defined.
■ Data ( d ) specifies a bit printed to 1 and not printed to 0. The dot pattern is in the horizontal direction from
the left side. Any remaining dots on the right side are blank.
■ The data to define a user-defined character is ( y × x ) bytes.
■ When the value of y , c1 , c2 , or x is out of the range, this command is canceled, and the following data is
processed as normal data.
■ This command can define user-defined characters for each font independently. To select a font, use ESC !
or ESC M.