Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Print position commands ESC W
Ver. 10.01 p. 178
TM-T88III
The vertical or horizontal motion unit is specified by GS P.
TM-L90
The vertical or horizontal motion unit is specified by GS P.
When a set value of the paper layout (horizontal and vertical size of the print area) is smaller than
the print area (initial value of this command), it is not possible to print in the area where the
paper layout (horizontal and vertical size of the print area) is exceeded.
See Function 5 of GS ( E for specifying the paper width and paper (monochrome paper or two-
color paper).
See Functions 49 and 50 of GS ( E for the paper layout (receipt/label paper, horizontal and vertical
size of print area).
TM-P60
The vertical or horizontal motion unit is approximately 0.125 mm {1/203 inches}. This value equals
one dot pitch.
See Function 5 of GS ( E for specifying the paper width.
TM-L60II
The vertical or horizontal motion unit is specified by GS P.
The paper type, thermal paper or label paper, is selected by a DIP switch:
■ Serial interface model: DIP switch [SW2-6]
■ Parallel interface model: DIP switch [SW1-7]

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English