CONFIDENTIAL
Paper roll Bit-image commands ESC *
Ver. 10.01 p. 206
TM-U220
The modes selectable by
m
are as follows:
■ “Vertical” is in the direction of paper feeding and “horizontal” is perpendicular (at right
angles) to the direction of paper feeding.
■ The maximum number of dots for printing depends on a DIP switch [SW2-1] setting and paper
width. See the description of GS ( E <Function 5> for details.
dpi: dots per 25.4 mm (dots per inch)
m
Mode Vertical dot density Horizontal
Dot density Set adjacent dots Maximum number of dots
SW2-1: ON SW 2-1: OFF
Paper Width:
76/ 69.5/ 57.5 (mm)
Paper Width
76/ 69.5/ 57.5 (mm)
0 8-dot single-density 72 dpi 80 dpi Permitted 192/ 180/ 148 200/ 180/ 150
1 8-dot double-density 72 dpi 160 dpi Prohibited 385/ 360 / 297 400/ 360/ 300
To Next Page
Loading...
Need help?
General