Epson TM-T88III

CONFIDENTIAL
Paper roll Bar code commands GS k
Ver. 10.01 p. 351
■ In CODE A, following data can be used.
Character data: It is specified by ASCII code [in hexadecimal: 20H ~ 5FH / in decimal: 32~95]
Control character data: It is specified by ASCII code [in hexadecimal: 00H ~ 1FH / in decimal: 0~31]
Special character data: (FNC 1, FNC 2, FNC 3, FNC 4, SHIFT, CODE B, CODE C)
It is specified “{+ character code" as 2 byte. (It is described separately.)
■ In CODE B, following data can be used.
Character data: It is specified by ASCII code [in hexadecimal: 20H ~ 7FH / in decimal: 32~127]
when specify "{", transmit “{{“ as 2 byte data. (It is described separately.)
Special character data: (FNC 1, FNC 2, FNC 3, FNC 4, SHIFT, CODE A, CODE C)
It is specified “{+ character code" as 2 byte. (It is described separately.)
■ In CODE C, following data can be used.
Numerical data: It is specified each 2 digit as 1 byte by ASCII code
[in hexadecimal: 00H ~ 63H / in decimal: 0~99]
Example: When specify "012345", specify [in hexadecimal: 01H, 17H, 2DH.
in decimal: 1, 23, 45] as 3 byte.
Special character data: (FNC 1, CODE A, CODE B)
It is specified “{+ character code" as 2 byte. (It is described separately.)
■ Special characters are defined by combining two characters "{ + an alphanumeric character." The ASCII
character "{" is defined by transmitting "{" twice consecutively.
Specific character
Transmit data
ASCII Hex Decimal
SHIFT {S 7B, 53 123, 83
CODE A {A 7B, 41 123, 65
CODE B {B 7B, 42 123, 66
CODE C {C 7B, 43 123, 67
FNC1 {1 7B, 31 123, 49
FNC2 {2 7B, 32 123, 50