Epson TM-T88III

CONFIDENTIAL
Paper roll Miscellaneous commands DLE DC4 (fn = 2)
Ver. 10.01 p. 387
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-L90, TM-P60
TM-J2000/J2100
The BUSY condition is selected by memory switch 1-3.
While processing a set up of power-off, the POWER LED blinks fast and changes to slow blinking
after the printer transmits a power-off notice. Be sure that the POWER LED blinks slowly; then turn
off the power switch.
When DIP switch 1-1 is ON, the power will not be turned off by this command. Be sure that the
power is turned off by an operator.
TM-T90
The BUSY condition is selected by memory switch 1-3.
While processing a set up of power-off, the POWER LED blinks fast and changes to slow blinking
after the printer transmits a power-off notice. Be sure that the POWER LED is blinking slowly; then
turn off the power switch.
When DIP switch [SW1-1] is ON, the power will not be turned off by this command. Be sure that
the power is turned off by an operator.
Program Example
PRINT #1, CHR$(&H10);CHR$(&H14);CHR$(2);CHR$(1);CHR$(8);
GOSUB *RECEIVE ← Confirmation “power off notice“