Epson TM-T88III

CONFIDENTIAL
Paper roll Customize commands GS ( E
Ver. 10.01 p. 620
TM-T90
This printer does not support this function.
TM-U220
This printer does not support this function.
TM-L90
In the following cases, the parameter is the wrong value. If these parameters are processed, the value is not
set.
When sa = “49“
sb ≤ sd
sb ≤ se
sb < sf
width of paper < sg + sh + 33
(when width of paper is less than or
78 mm {3.1 inches})
width of paper < sg + sh + 43
(when width of paper is less than or
79 mm {3.1 inches})
width of paper < sg + sh + 53
(when width of paper is less than or
80 mm {3.1 inches})
When sa = “64“
sd < sc
sc ≤ se
sb < sg + sf
width of paper < sg + sh + 53
When “bottom of a label” is specified as layout of origin (s a = 64), paper layout error occurs in any of the
following states:
■ When the top of the label is detected by performing paper feed less than “setting value of
sc – 1 mm”,
after passing the origin of layout.