CONFIDENTIAL
Paper roll Customize commands GS ( E
Ver. 10.01 p. 621
■ When the next origin of layout is not detected by performing paper feed “setting value of
sb
× 1.12,” after passing the origin of layout.
■ When the next origin of layout is detected by performing paper feed less than “setting value of
sb
× 0.88,”
after passing top of the label.
■ When the next origin of layout is not detected by performing paper feed “setting value of
sb
× 1.12,” after passing top of the label.
When “top of a black mark” is specified as the origin of layout (
sa
= 49), paper layout error occurs in either of
the following states:
■ When the bottom of the black mark is detected by performing paper feed less than “setting value of
sc
–1
mm”, after passing the origin of layout.
■ When the next origin of layout is not detected by performing paper feed “setting value of
sb
× 1.12,” after passing the origin of layout.
■ When the next origin of layout is detected by performing paper feed less than “setting value of
sb
× 0.88,”
after passing top of the print area.
■ When the next origin of layout is not detected by performing paper feed “setting value of
sb
× 1.12,” after passing top of the print area.
■ Paper layout setting value can be changed in the automatic setting mode of paper layout by panel
operation when the printer power is turned on. However if paper to be used is a label (with a black mark),
the automatic setting mode cannot be used. Paper layout needs to be set by this function. When memory
switch [Msw8-2] is OFF, in addition to the standard specification, paper layout stored in the non-volatile
memory is rewritten by recovery process from a paper layout error. For details, see DLE ENQ of printer
information for recovery process from a layout error.
TM-P60
This printer does not support this function.
To Next Page
Loading...
Need help?
General