!
Warning:
Do not use conductive paper such as origami paper, carbonic paper or conductively-coated paper.
When paper jam occurs, it may cause short-circuit and eventually a fire accident.
See Also:
❏ “Loading Print Media in the Paper Tray” on page 123
❏ “Loading Print Media in the Priority Sheet Inserter (PSI)” on page 132
❏ “Loading Envelopes in the Paper Tray” on page 128
❏ “Loading Envelopes in the Priority Sheet Inserter (PSI)” on page 135
❏ “Printing on Custom Size Paper” on page 154
Automatic Document Feeder (ADF) Guidelines
The ADF can accommodate the paper of the following sizes:
❏ Width: 148–215.9 mm (5.83–8.50 inches)
❏ Length: 210–355.6 mm (8.27–14.00 inches)
The supported paper weight ranges from 60 to 105 gsm.
Follow the guidelines below when loading source documents into the ADF:
❏ Load documents face up so that the top of the document enters the printer first.
❏ Place only loose sheets of paper in the ADF.
❏ Adjust the document guides so that they fit against the documents.
❏ Insert paper in the document feeder tray only when the ink on the paper is completely dry.
AL-MX200 Series User’s Guide
Printing Basics 116
To Next Page
Loading...
